Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi page 8

3. Ceiling Fan Assembly
3.9
Carefully turn the partially assembled Ceiling Fan upside
down, place the Ceiling Fan onto the two carton styrofoam
pieces, in preparation for final assembly (Figure 9).
Remove each of the Ten Spacer Screws and Five Rubber
Shipping Spacers from the Motor Hub before installation of
Blade Assemblies (Figure 9).
Discard the Five Rubber Shipping Spacers and Ten
Spacer Screws.
3.10
NOTE: Your ceiling fan will operate with the following
Blade Select Blades (Sold Separately):
B77, B78, B79, B90, B91, B92, B97, B100, B101, B102,
B103, B107, B108, B109, G44, G54, & G60.
Mount the Fan Blade (sold separately) using the Four
#10-24 x 12mm Round Head Screws and Flat Washers
(supplied in parts bag) to secure Flange to Blade
(Figure 10).
Repeat for the remaining Four Blades.
Make sure all Screws are tighten securely in the Fan Blade
and Flange.
NOTE: Some accessory blades are supplied with
shorter screws. These shorter screws MUST be used
to assemble the blades to flanges.
(Continued)
PARTIALLY
ASSEMBLED
CEILING FAN
STYROFOAM
PIECES
Figure 9
#10-24 x 12mm
ROUND HEAD SCREW
(4 per blade/flange)
FLAT WASHER
(4 per blade/flange)
BLADE FLANGE
Figure 10
8
REMOVE & DISCARD
5 RUBBER SHIPPING
SPACERS & 10 SCREWS
FAN BLADE
(sold
separately)