Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi page 20

8. Wall Control Installation
3-WAY INSTALLATION
(One fan controlled by two different wall controls)
(See Figures 29 and 30).
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse or circuit breaker box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
8.10
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
8.11
At all Wall Box locations remove Faceplates and Screws
from Existing Controls. Pull Controls out from Wall Boxes
and determine which Wall Box contains the "hot" Lead and
which Wall Box contains the "load" Wire. Also, identify
Traveler Wires which are common to both Wall Boxes.
Disconnect Wires from Existing Controls only.
Do not attempt to disconnect any Wires not already
connected to Existing Controls.
8.12
Before installing Wall Control, place Wall Control in "OFF"
mode by pushing "ON/OFF" Switch to the "OFF" position.
8.13
Install a Wall Control in the Wall Box containing the "hot"
Wire first. Connect the Black Wire of the Wall Control to the
"hot" Wire. Securely connect Wires with Wire Connector
supplied.
8.14
Connect one Black Wire of the Wall Control to both
remaining Traveler Wires in the Wall Box and secure with
Wire Connector supplied.
(Continued)
SW605
BLK
HOT
FAN/LIGHT
WALL
CONTROL
BLACK
TRAVELER
WIRE
NEUTRAL
RECEIVER LOCATED WITHIN THE
CEILING COVER OF THE CEILING FAN
Figure 29
20
LOAD
BLACK
GROUND