Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi page 21

8. Wall Control Installation
3-WAY WIRING DIAGRAM:
NEW CONSTRUCTION
NOTE: Retrofit 3-way installations are likely to include
two traveler wires between the two wall boxes.
In new construction, only one traveler wire Is required
(See Figure 30).
WARNING
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
8.15
Screw the SW605 Wall Control into Wall Box using the
supplied Screws. Leave Wall Control in "OFF" mode until
Fan installation is completed.
8.16
Next, install the other SW605 Wall Control into the Wall
Box containing the Load Wire. Connect the Black Wire of
the SW605 Wall Control to the Traveler Wire(s) already
connected to the Black Wire (in the other wall box). Secure
with Wire Connectors supplied.
8.17
Connect One Black Wire of the SW605 Wall Control to the
"load" (black) Wire and secure with Wire Connector
supplied.
8.18
Connect One Black Wire of the SW605 Wall Control to
both remaining Traveler Wires in the Wall Box and secure
with Wire Connector supplied.
8.19
Screw the SW605 Wall Control into Wall Boxes using the
supplied Screws. Leave the SW605 Wall Control in "OFF"
mode until Fan installation is completed.
(Continued)
STANDARD WIRING FOR EXISTING
3-WAY CONTROLS
HOT
BLK
3-WAY WIRING DIAGRAM: RETROFIT
HOT BLK
BLK
SW605
FAN/LIGHT
WALL
CONTROL
Figure 30
8.20
The SW605 Wall Control is supplied with a White, Ivory,
and Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the
SW605 Wall Control (Refer to Figure 28).
8.21
Install Decorator Wall Plates using the Two Screws
provided with Wall Plate. Leave the SW605 Wall Control
in "OFF" mode until Fan installation is completed
(Refer to Figure 28).
21
EXISTING
WALL CONTROL
TRAVELER WIRES
BLK
BLK
SW605
TRAVELER
FAN/LIGHT
WIRES
WALL
CONTROL
LOAD
LOAD