Wall Control Installation - Emerson PENBROOKE SELECT ECO CF5200AP00 Mode D'emploi

Ventilateur de plafond
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

8.1
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse or circuit breaker box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
This Control is designed to operate only one Ceiling Fan
NOTE: Electric connections should be in accordance
with the National Electrical Codes and all Local
Codes. Before starting, disconnect power to the
circuit at the fuse box or circuit breaker panel.
Remove the Faceplate and Screws from the Existing Wall
Switch. Pull Switch out from Wall Outlet Box.
Disconnect the Wire from the Existing Fan Wall Switch
(Figure 26).
SINGLE-POLE INSTALLATION
CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the fan, light kit or receiver.
NOTE: Make all wiring connections using wire
connectors (supplied). Make sure that all connections
are tight, including ground, and that no bare wire is
visible at the wire connectors, except for the ground
wire.
8.2
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
8.3
Remove Faceplate and Screws from Existing Wall Control.
Pull Control out from the Wall Box. Determine the "hot"
Wire and the "load" Wire and disconnect these Wires from
Control (Figure 27).
Do not attempt to disconnect any Wires not already
connected to Existing Control.

8. Wall Control Installation

SCREWS
Figure 26
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse or circuit breaker box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
HOT
BLK
NEUTRAL
RECEIVER LOCATED IN THE CEILING
COVER OF THE CEILING FAN
Figure 27
18
OUTLET
WALL
BOX
SWITCH
FACEPLATE
WARNING
SW605 FAN/LIGHT
WALL CONTROL
BLACK
GROUND

Publicité

Table des Matières
loading

Table des Matières