Wall Control Installation - Emerson RAH ECO CF915TM60BS00 Mode D'emploi

7.1
Your Emerson Ceiling Fan/Light Control consists of wall
mounted transmitter and a receiver located inside the
motor assembly. The control is designed to remotely
operate your ceiling fan speed, light intensity and direction
of rotation.
Code switches in the transmitter may be set in
32 different positions. If your fan and light turn on and off
without using your control, you may be getting interference
from other remote units such as garage door openers, car
alarms or security systems. To remedy this situations,
simply change the code switches in your transmitter per
the instructions of Section 7.3.
7.3
Your Wall Control has Code Switches which must be set
in one of 32 possible code combinations (Figure 30). The
five levers (numbered 1, 2, 3, 4, and 5) on the Switches
are factory-set in the ON (up) position. Change the Switch
settings as follows:
Slide the five Switch Levers in the Wall Control to your
choice of ON (up) or down positions. Use a ball-point pen
or small screwdriver and slide the Levers firmly up or
down.
The sixth Switch marked ON and I is for dimming control
of lights: Set Switch to ON to allow for dimming of the
lighting. Set Switch to I for no dimming of the lighting.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse or circuit breaker box before wiring. All wiring
must be in accordance with National and Local codes
and the ceiling fan must be properly grounded as a
precaution against possible electrical shock.
CAUTION:
To reduce the risk of electrical shock, disconnect
the electrical supply circuit before installing the
fan, light kit or receiver.

7. Wall Control Installation

7.2
Preset Memory Feature: Your Emerson receiver is
equipped with a preset memory feature. If the AC supply
to the receiver is powered OFF through a wall switch, the
control will remember the light intensity and fan speed.
When the switch is turned back ON the light and fan will
resume operation as they were prior to the switch being
turned OFF.
Figure 30
NOTE: Make all wiring connections using Wire
Connectors (supplied). Make sure that all connections
are tight, including ground, and that no bare wire is
visible at the wire connectors, except for the ground
wire.
7.4
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install the
Ceiling Fan Wall Control into the Outlet Box.
18
WALL CONTROL
CODE SWITCHES
1 - 5
ON
1
2 3 4 5 I
DIMMING
SWITCH
I
CODE
SWITCHES
WALL
CONTROL
U.L. Model No.: CF915