Final Installation - Emerson RAH ECO CF915TM60BS00 Mode D'emploi

5. How to Wire Your Ceiling Fan
5.5
Screw the two Threaded Studs (supplied) into the tapped
holes in the Hanger Bracket (Figure 20).
Your Fan is now wired to be turned on and off from the
Fan Switch.
6.1
Lift the Ceiling Cover up to the Threaded Studs and turn
until Studs protrude through the holes in the Ceiling Cover
(Figure 21).
Secure the Ceiling Cover in place by sliding Lockwashers
over the Threaded Studs and installing the two Knurled
Knobs (supplied) (Figure 21).
Tighten the Knurled Knobs securely until the Ceiling Cover
fits snugly against the Ceiling and the hole in the Ceiling
Cover is clear of the Downrod.
WARNING
!
To avoid possible fire or shock, make sure that the electrical
wires are completely inside the outlet box and not pinched
between the ceiling cover and the ceiling.
Figure 20

6. Final Installation

NOTE: SUPPLY WIRES AND FAN WIRES OMITTED FOR CLARITY.
CEILING
COVER
THREADED STUD (2)
LOCKWASHER (2)
KNURLED KNOB (2)
Figure 21
13
(Continued)
HANGER
BRACKET
THREADED
STUD (2)
DOWNROD
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF915