Final Assembly - Emerson DUO CF560BS00 Mode D'emploi

6.1
Remove and retain the two opposite 10-24 x 3/8" Pan
Head Ceiling Cover Screws from the Ceiling Mounting
Plate (Figure 13A).
Loosen the remaining two opposite 10-24 x 3/8" Pan Head
Ceiling Cover Screws from the Ceiling Mounting Plate
(Figure 13A).
Unhook the Fan Motor Assembly from the Ceiling
Mounting Plate Hook and lift the Fan Motor Assembly up to
the Ceiling Mounting Plate.
Align the two Fan Motor Assembly Slots with the two
Screw Heads previously loosened (Figure 13B).
Rotate the Fan Motor Assembly clockwise to engage the
Screw heads into the two Fan Motor Assembly Slots
(Figure 13B).
NOTE: For correct alignment: place the Ceiling
Mounting Plate Hook into the opening of the Receiver,
located in the Fan Motor Assembly.
Reinstall the two previously removed 10-24 x 3/8"
Pan Head Ceiling Cover Screws (Figure 13B).
Completely tighten all four 10-24 x 3/8" Pan Head Ceiling
Cover Screws to secure the Fan Motor Assembly to the
Ceiling Mounting Plate (Figure 13B).
A spare 10-24 x 3/8" Pan Head Ceiling Cover Screw is
supplied in parts bag, if needed.
WARNING
!
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the outlet box and
not pinched between the ceiling mounting plate and the
fan motor housing assembly.
6.2
Position the Ceiling Trim Ring over each of the four
protruding 10-24 x 3/8" Screw Heads and rotate the Ceiling
Trim Ring clockwise to secure (Figure 14).

6. Final Assembly

Figure 13A
WIRES REMOVED FOR CLARITY
RETIGHTEN TWO OPPOSITE
10-24 x 3/8" PAN HEAD SCREWS
Figure 13B
10-24 x 3/8"
SCREW HEADS (4)
CEILING TRIM RING
Figure 14
12
REINSTALL TWO OPPOSITE
10-24 x 3/8" PAN HEAD SCREWS
U.L. Model No.: CF560
CEILING
MOUNTING
PLATE
FAN MOTOR
ASSEMBLY