18Mm Phillips Washer Head Screws; #10-24 X 3/8" Phillips Washer Head Screws; Fiber Washers - Emerson RAH ECO CF915TM60BS00 Mode D'emploi

6.2
Mount a Medallion to the Fan Blade using three
10-24 x 3/8" Phillips Washer Head Screws and three Fiber
Washers (supplied) (Figure 22).
Complete the remaining five Blades Assemblies per the
above instructions.
6.3
Slide Blade Assembly through the Blade Slot in Fan Motor
Assembly.
NOTE: Make sure the Medallion is facing toward the
bottom of the Fan.
Position the Blade Support onto the Blade, aligning the
three holes of the Blade Support with the Blade holes
(Figure 23).
Mount the Blade and Blade Support to the Fan Motor
Assembly using three #10-24 x 18mm Phillips Washer
Head Screws (supplied). Loosely secure the center screw,
then the outer two screws. Then tighten the three screws
to secure the Blade and Support to the Fan Motor
Assembly.
Complete the installation of the remaining five Blades per
the above instructions.
NOTE: Take care not to scratch Fan Motor Assembly
when installing Blades.
WARNING
!
To reduce the risk of personal injury, do not bend the
blade assemblies when installing the fan blades,
balancing the blades or cleaning the fan. Do not insert
foreign objects in between rotating fan blades.
6. Final Installation
(Continued)
Figure 22
Figure 23
14
10-24 x 3/8" PHILLIPS
WASHER HEAD
SCREWS (3 per blade)

FIBER WASHERS

(3 per blade)
FAN
BLADE
MEDALLION
BLADE SLOT
MEDALLION
BLADE ASSEMBLY
BLADE SUPPORT
#10-24 x 18mm
PHILLIPS WASHER HEAD
SCREWS (3 per blade)
U.L. Model No.: CF915