Remote Control Procedures - Emerson VOLTA CF590BQ00 Mode D'emploi

Ventilateur de plafond pour environnement humide de 54 po
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10.1
Your Emerson Ceiling Fan/Light Remote Control
consists of hand-held transmitter and a receiver which
is mounted under the fan ceiling cover. The remote
control is designed to separately control your ceiling fan
speed and light intensity.
The remote control transmitter is powered by two AAA
alkaline batteries (included). To prevent possible
damage if the batteries should leak, be sure to remove the
batteries when the control is not to be used for an
extended period of time.
Code switches in the transmitter and receiver may be
set in 32 different positions. If your fan and light go on
and off without using your control, you may be getting
10.3
Installation of Batteries: Remove the battery cover by
pressing firmly below the arrow and sliding the cover off
the control (Figure 35).
Install two AAA alkaline batteries and reinstall the battery
cover (Figure 35).
10.4
Installation of Storage Bracket for Remote Control: A
storage bracket is provided for holding your remote control
when not in use. If you desire to use the bracket, install it
on a wall that is away from excess heat or humidity
(Figure 36).

10. Remote Control Procedures

interference from other remote units such as garage
door openers, car alarms or security systems.
To remedy this situations, simply change the combination
code in your transmitter and receiver.
10.2
Preset Memory Feature: Your Emerson receiver is
equipped with a preset memory feature. If the AC supply
to the receiver is powered through a wall switch, when the
switch is turned OFF, the control will remember the light
intensity and fan speed. When the switch is turned back
ON the light and fan will resume operation as they were
prior to the switch being turned OFF.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 35
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 36
20
REMOTE CONTROL
LEVERS
1
2
3
4 5
CODE
SWITCHES
REMOTE CONTROL
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
ETL Model No.: CF590

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Volta cf590grt00Volta cf590pt00Volta cf590sw00Cf590bq00Cf590pt00Cf590sw00

Table des Matières