Emerson VOLTA CF590BQ00 Mode D'emploi page 7

3. Ceiling Fan Assembly
3.7
Loosen the two setscrews in the motor coupler for
installation of the downrod (Figure 7).
Seat the downrod in the motor coupler (Figure 7).
Rotate and align the downrod holes with all the holes in the
motor coupler (Figure 7).
3.8
Align the clevis pin holes in the downrod with the holes in
the motor coupler.
Install the clevis pin and secure with the hairpin clip
(Figure 8).
The clevis pin must go through the holes in the motor
coupler. It is critical that the clevis pin in the motor coupler
is properly installed and securely tightened.
Retighten the Phillips head setscrews to secure the
downrod to the motor (Figure 8).
WARNING
!
It is critical that the clevis pin and setscrews in the motor
coupler are properly installed and securely tightened.
Failure to verify that the pin and setscrews are properly
installed could result in the fan falling.
3.9
Make sure the grommet is properly installed in the
coupling cover, then slide the coupling cover on the
downrod until it rests on the fan motor housing
(Figure 9).
(Continued)
LOOSEN
PHILLIPS HEAD
SETSCREWS (2)
Figure 7
HAIRPIN
CLIP
CLEVIS
PIN
CLEVIS
PIN
RETIGHTEN
PHILLIPS HEAD
SETSCREWS (2)
Figure 8
FAN MOTOR
HOUSING
Figure 9
7
4.5"
DOWNROD
MOTOR
COUPLING
MOTOR
COUPLING
HAIRPIN
CLIP
DOWNROD
GROMMET
COUPLING
COVER
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF590