Emerson VOLTA CF590BQ00 Mode D'emploi page 27

13. Light Kit LED Driver Replacement
13.13
Reconnect the motor AC power connector to the Light Kit
LED Driver connector (Figure 50).
Reconnect the motor DC power connector to the Light Kit
LED Driver connector (Figure 50).
13.14
Replace the upper motor cover by reinstalling the
six upper motor cover screws, previously removed in Step
13.9 (Figure 51).
13.15
Route the three motor leads through the 4.5" downrod
(Figure 52). Re-seat the downrod in the motor coupling.
Rotate and align the two downrod holes with the two holes
in the motor coupler as shown in Figure 52.
NOTE: It is important to keep the downrod holes
aligned with the motor coupler holes while reinstalling
the two setscrews.
Reinstall the two setscrews (previously removed) into the
motor coupler to capture the downrod in place (Figure 52).
MOTOR AC POWER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
Figure 50
REINSTALL UPPER
MOTOR COVER
SCREWS (6)
UPPER
MOTOR COVER
Figure 51
REINSTALL
PHILLIPS HEAD
SETSCREWS (2)
Figure 52
27
(Continued)
MOTOR DC POWER
CONNECTOR
LIGHT KIT
LED DRIVER
DOWNROD
MOTOR
COUPLING
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF590