Emerson VOLTA CF590BQ00 Mode D'emploi page 26

13. Light Kit LED Driver Replacement
13.10
Squeeze and unclip the motor AC power connector from
the Light Kit LED Driver connector (Figure 47).
Squeeze and unclip the motor DC power connector from
the Light Kit LED Driver connector (Figure 47).
13.11
Remove the two Phillips head screws from the Old Light
Kit LED Driver (Figure 48).
Retain the screws for future reinstallation.
Gently pull up on the Old Light Kit LED Driver. Remove the
Driver from the motor housing (Figure 48).
Discard the Old Light Kit LED Driver in the correct
recycle bin.
13.12
Place the New Light Kit LED Driver into the motor
housing, aligning it directly where the Old Driver had been
(Figure 49).
Install the New Light Kit LED Driver to the motor housing
using the two screws previously removed (Figure 49).
MOTOR AC POWER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
LIGHT KIT
LED DRIVER
CONNECTOR
Figure 47
REMOVE & RETAIN PHILLIPS
HEAD SCREWS (2)
OLD LIGHT KIT
LED DRIVER
Figure 48
REINSTALL THE PHILLIPS
HEAD SCREWS (2)
NEW LIGHT KIT
LED DRIVER
Figure 49
26
(Continued)
MOTOR DC POWER
CONNECTOR
LIGHT KIT
LED DRIVER
ETL Model No.: CF590