Emerson VOLTA CF590BQ00 Mode D'emploi page 14

6. No-Light Plate Assembly
6.4
Place the no-light plate into the opening of the Light Kit
Adapter, aligning the three flat areas on the top edge of
the no-light plate with the three raised dimples on the
Light Kit Adapter and turn the plate clockwise until it
stops (Figure 23).
NOTE: The no-light plate is equipped with an
interference device that will not allow it to be installed
if the light kit assembly is not removed.
NOTE: Periodically check that the no-light plate is
seated fully clockwise in the Light Kit Adapter.
(Continued)
FLAT AREA OF
NO-LIGHT PLATE
Figure 23
14
H
INTERFERENCE
ROTATE
CLOCKWISE DEVICE
LIGHT KIT
ADAPTER
RAISED
DIMPLES (3)
NO-LIGHT PLATE
ETL Model No.: CF590