Emerson VOLTA CF590BQ00 Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
Carefully turn the partially assembled ceiling fan right side
up and position the fan on the styrofoam in preparation for
final assembly (Figure 4).
3.5
Remove the hanger ball by loosening the Phillips head
setscrew in the hanger ball until the ball falls freely down
the 4.5" downrod (Figure 5).
Remove the pin from the 4.5" downrod, then remove the
hanger ball (Figure 5).
Retain the pin and hanger ball for reinstallation in
Step 3.11.
3.6
Separate, untwist and unkink the three 80" motor leads.
Route the three motor leads through the 4.5" downrod
(Figure 6).
(Continued)
Figure 4
PIN
PHILLIPS HEAD SET SCREW
(LOOSENED)
Figure 5
THREE 80" MOTOR LEADS
Figure 6
6
PARTIALLY ASSEMBLED
CEILING FAN
STYROFOAM
GREEN GROUND WIRE
4.5" DOWNROD
HANGER BALL
4.5" DOWNROD
ETL Model No.: CF590