Wall Control Procedures - Emerson PORTLAND CF965BS00 Instructions

8.1
Your Emerson Ceiling Fan/Light Control consists of
SW605 wall mounted transmitter and a receiver located
inside the motor assembly. The control is designed to
remotely operate your ceiling fan speed, light intensity and
direction of rotation.
8.2
Your SW605 wall control has code switches which must
be set in one of 32 possible code combinations
(Figure 31). The five levers (numbered 1, 2, 3, 4, and 5)
on the switches are factory-set in the ON (up) position.
Change the switch settings as follows:
NOTE: Do not duplicate the code of an existing
control of an installed ceiling fan within 100 feet.
8.3
Slide the five switch levers in the SW605 wall control to
your choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the levers firmly up or
8.4
down.
The sixth switch marked ON and I is for dimming control of
lights: Set switch to ON to allow for dimming of the lights.
Set switch to I for no dimming of the lights such as for
8.5
fluorescent bulbs and non-dimming CFLs.
Preset Memory Feature: Your Emerson ceiling fan/light
control is equipped with a preset memory feature. When
the electricity supply to the fan is switched OFF, the
control will remember the light intensity and fan speed.
When the switch is turned back ON, the light and fan will
resume operation as they were prior to the switch being
turned OFF.

8. Wall Control Procedures

Code switches in the transmitter may be set in
32 different positions. If your fan and light turn on and off
without using your control, you may be getting interference
from other remote units such as garage door openers, car
alarms or security systems. To remedy this situations,
simply change the code switches in your transmitter per
the instructions of Section 10.
Figure 31
Please contact 1-800-654-3545 for further assistance
19
SW605 WALL CONTROL
CODE SWITCHES
ON
1
2 3 4 5 I
CODE
SWITCHES
SW605 WALL
CONTROL
emersonfans.com
ETL Model No.: CF965