Optional Al100 Accent Light Installation - Emerson PORTLAND CF965BS00 Instructions

7. Optional AL100 Accent Light Installation

CAUTION: To reduce the risk of electrical shock,
disconnect the electrical supply circuit before
installing the accent light kit.
7.1
Loosen and remove all three pre-installed AL100 mounting
screws from the upper housing of the motor assembly
(Figure 28). Retain the screws for re-installation.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the main
fuse or circuit breaker box before wiring. All wiring must be
in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
7.2
CAUTION: To reduce the risk of electric shock,
disconnect the electrical supply circuit to the fan
before installing light kit assembly.
Position the AL100 accent light so that the opening of the
AL100 accent light slides through the downrod. Align the
mounting holes of the AL100 accent light to the motor
NOTE: Be sure the AL100 accent light connector is
assembly (Figure 29).
located close to the motor assembly connector for
ease of installation.
Install the AL100 accent light to the motor assembly using
three AL100 accent
previously removed on Step 7.1.
7.3
Securely connect the AL100 accent light connector to the
motor assembly connector (Figure 30).
Screw the four 25-watt candelabra base bulbs into the
AL100 accent light sockets (Figure 30).
Return to Section 3.17 and complete the
remaining installation instructions.
light mounting screws
LOWER HOUSING
SCREWS (4)
Figure 28
LOWER
HOUSING
SCREWS (4)
AL100 ACCENT
LIGHT HARNESS
CONNECTOR
FAN MOTOR ACCENT
LIGHT CONNECTOR
Figure 29
25-WATT CANDELABRA
BASE BULBS (4)
Figure 30
18
GLASS
SHADE
AL100 ACCENT
LIGHT HARNESS
AL100 ACCENT
LIGHT SOCKETS (4)
LIGHT KIT & FAN MOTOR
ACCENT LIGHT CONNECTORS
ETL Model No.: CF965