Wall Control Procedures - Emerson AIRA ECO CF985BS00 Mode D'emploi

10.1
Your Emerson Ceiling Fan/Light Control consists of
SW605 wall mounted transmitter and a receiver located
inside the motor assembly. The control is designed to
remotely operate your ceiling fan speed, light intensity and
direction of rotation.
10.2
Your SW605 wall control has code switches which must
be set in one of 32 possible code combinations
(Figure 32). The five levers (numbered 1, 2, 3, 4, and 5)
on the switches are factory-set in the ON (up) position.
Change the switch settings as follows:
NOTE: Do not duplicate the code of an existing
control of an installed ceiling fan within 100 feet.
10.3
Slide the five switch levers in the SW605 wall control to
your choice of ON (up) or down positions. Use a ball-point
pen or small screwdriver and slide the levers firmly up or
10.4
down.
The sixth switch marked ON and I is for dimming control of
lights: Set switch to ON to allow for dimming of the lights.
Set switch to I for no dimming of the lights such as for
10.5
fluorescent bulbs and non-dimming CFLs.
Preset Memory Feature: Your Emerson ceiling fan/light
control is equipped with a preset memory feature. When
the electricity supply to the fan is switched OFF, the
control will remember the light intensity and fan speed.
When the switch is turned back ON, the light and fan will
resume operation as they were prior to the switch being
turned OFF.

10. Wall Control Procedures

Code switches in the transmitter may be set in
32 different positions. If your fan and light turn on and
off without using your control, you may be getting
interference from other remote units such as garage
door openers, car alarms or security systems.
To remedy this situations, simply change the code
switches in your transmitter per the instructions of
Section 12.
Figure 32
18
SW605 WALL CONTROL
CODE SWITCHES
ON
1 2 3 4 5
I
CODE
SWITCHES
SW605 WALL
CONTROL
E.T.L. Model No.: CF985