Emerson AIRA ECO CF985BS00 Mode D'emploi page 6

3. Ceiling Fan Assembly
3.4
Loosen the two setscrews in the motor coupling.
Place the 6" downrod into the motor coupling, aligning the
clevis pin holes in the downrod with the holes in the motor
coupling (Figure 3).
The clevis pin must go through the holes in the motor
coupling and the holes in the downrod.
Be sure to push the straight leg of the hairpin clip through
the hole near the end of the clevis pin until the curved
portion of the hairpin clip snaps around the clevis pin.
The hairpin clip must be properly installed to prevent the
clevis pin from working loose.
Pull on the downrod to make sure the clevis pin is properly
installed.
WARNING
!
It is critical that the clevis pin in the motor coupling is
properly installed. Failure to verify that the pin is properly
installed could result in the fan falling.
3.5
While pulling up on the 6" downrod, retighten the two
setscrews (previously loosened) in the motor coupling to
NOTE: The setscrews must be properly installed as
secure the downrod into place (Figure 4).
described above, or fan wobble could result.
WARNING
!
It is critical that the setscrews are securely tightened.
Failure to verify that the setscrews are properly installed
could result in the fan falling.
3.6
Route the 80" black and white motor leads through the
coupling cover (Figure 5).
Make sure the grommet is properly installed in the
coupling cover then slide the coupling cover on the
downrod until it rests on the motor housing (Figure 5).
(Continued)
6" DOWNROD
CLEVIS
PIN
MOTOR
COUPLING
MOTOR
COUPLING
Figure 3
MOTOR COUPLING
Figure 4
COUPLING COVER
MOTOR
HOUSING
Figure 5
6
HAIRPIN
CLIP
CLEVIS
PIN
HAIRPIN
CLIP
LOOSEN
SETSCREWS (2)
6" DOWNROD
RETIGHTEN
SETSCREWS (2)
6" DOWNROD
COUPLING COVER
GROMMET
E.T.L. Model No.: CF985