Description Of The Timing Light; Dash Board; General View - tecnotest 232-E Mode D'emploi

__________________________________________________________________________ TIMING LIGHT
2.0 -

DESCRIPTION OF THE TIMING LIGHT

2.1 -

Dash board

1. Advance degrees display: displays the advance degrees measured by the timing
light.
2. Timing Light advance degrees led: indicates that the reading of the advance
degrees by the timing light has been enabled.
3. Volt/Peak volt display: displays the volt and the peak volt measured values.
4. Sensor advance degrees led: indicates that the reading of the advance degrees
by the sensor has been enabled.
5. Positive sensor led: indicates that the positive sensor has been set.
6. Sensor selection key: allows the selection either of the positive or of the
negative sensor (at each pressure the sensor is switched from one sensor to the
other).
7. Negative sensor led: indicates that the negative sensor has been set.
8. Timing Light/sensor key: allows to switch the reading of the advance degrees
from the timing light to the sensor and viceversa. Il enables also the reading
setting to 4-time Gasoline, Diesel, 2-time Gasoline.
9. Revolution display: displays the engine revolutions measured by the timing
light.
2.2 -

General view

10. Deviator: increases or decreases the displayed advance degree value
(to set the manufacturer's value of the car to be tested).
11. FLASH key: starts the flash.
12. Complete cable including:
Volt cable: used Volt and Peak volt measurements.
Supply cable.
Revolution connector: measures the revolutions in the diesel and gasoline
engines (by using the two cables on issue or the RPM Adaptor for static
ignitions).
Sensor connector: measures the TDC information by sensor (by the cables
on issue) on the preset engines.
SERVICE MANUAL
39