Bosch MTS 6531 Manuel D'instructions page 19

6.8 Wireless communication with
network unsuccessful using
DWA131 E1 dongle
The D-Link DWA131 E1 dongle is not intended to
be used for computer wireless communication
to a network. The DWA131 E1 dongle is only
intended to be used with MTS 6531 for
Point-to-Point communication or Infrastructure
wireless communication.
Recommendations
1. Make sure you do not have two D-Link wire-
less dongles connected to the computer.
2. Make sure you are not trying to connect the
computer to your dealership network using
the DWA131 E1 dongle.
6.9 VCI Manager displays yellow
icon over MTS 6531
after previous use
There may be instances when Windows does
not recognize the installation of the DWA131
E1 wireless adapter. In these cases, Windows
may create a new wireless profile instead
of using the existing one already stored on
the computer. The yellow icon displayed
over your MTS 6531 instructs you to
plug in the USB connecting cable between
MTS 6531 and the computer.
Recommendations
¶
Unplug and then re-install your wireless
adapter. Windows will attempt to recognize
the wireless adapter. If successful, the yellow
icon will disappear and MTS 6531 will
be ready for wireless Point-to-Point commu-
nication.
Robert Bosch GmbH
Troubleshooting | MTS 6531 | 19
6.10 Computer application is un-
able to communicate with the
MTS 6531 over USB
The "VCI Manager" software must be installed
on the computer, and MTS 6531 must
be powered up before it will communicate.
MTS 6531 must be configured through
USB before it will communicate using any other
connection types.
Recommendations
If other applications including the VCI Manager
are able to connect to MTS 6531 then:
¶
Check the Windows Firewall settings to see if
the application is being blocked.
If all installed applications are unable to commu-
nicate with MTS 6531 then:
1. Connect MTS 6531 to the compu-
ter using USB, but do not connect it to the
vehicle.
!
Do not plug the MTS 6531 USB
connecting cable into a USB hub.
2. Verify that the USB connecting cables are
securely attached and MTS 6531 has
completed its power up sequence.
3. Start the "VCI Manager" program.
4. Does VCI Manager detect the
MTS 6531?
If "No", then:
$
Try a different USB connecting cable / port
on the computer.
$
Check the Windows Firewall to see if the
VCI Manager is blocked.
$
Check that the MTS 6531 USB
connection is detected by Windows.
2019-07-01
en
|
1 689 989 445