Bosch MTS 6531 Manuel D'instructions page 14

en 14 | MTS 6531 | Operation
4. Connect to your MTS 6531 in the VCI
Manager software.
5. Select the "Network Setup" tab.
6. In the "Wireless (802.11)" tab, select the
option "Activate wireless interface"
 The "IP address configuration" input field
beocmes active.
7. Select the option "Automatic assignment
of IP address" if your network assigns IP
addresses automatically.
i
If your network uses fixed IP addresses, your
IT administrator will assign the IP address
and subnet mask.
8. Select <Access Point >>.
9. Assign network name:
$
If the network uses a hidden SSID or is not
within range, the network name can be
enter via the option "Enter network name
(SSID)" .
$
If the network is within range, the net-
work can be selected via the option
"Select from list of available networks".
Press <Aktualisieren> (Update) to have
the MTS 6531 search for available
WLAN signals.
10. After the network name has been entered,
continue with <Configurieren>(Configure).
11. Enter the security settings for the network and
select <Weiter> (Next).
12. Select <Ja> (Yes) to configure the
MTS 6531 again, or <Nein> (No) to can-
cel the procedure.
13. Select the "Settings" tab and check that the
MTS 6531 was configured correctly.
i
By disconnecting the USB connection, you
can check whether configuration was suc-
cessful.
14. Back up the settings for future
|
1 689 989 445 2019-07-01
5.4.2
The MTS 6531 can be configured for
point-to-point wireless communication. The
following illustration shows a single diagnostic
device connected to a computer using point-to-
point wireless communication.
If you need to reconfigure Point-to-Point on your
MTS 6531, use the following procedure.
The steps presented below assume you are run-
ning the Windows 7 operating system on your
computer. The steps may differ depending on
the operating system.
1. Plug the WLAN USB adapter into an available
!
2. Switch on your computer.
3. Connect the MTS 6531 to your com-
!
4. Start the "VCI Manager" program.
i
changes.
Enabling point-to-point wireless com-
munication
USB port on your computer.
Do not plug the wireless adapter into a USB hub.
puter via the USB connecting cable and allow
the MTS 6531 to boot completely.
Do not plug the MTS 6531 USB
connecting cable into a USB hub.
The Point-to-Point connection is automatically
configured. Wireless communication will be
available when you are powered through the
DLC cable.
Robert Bosch GmbH