Bosch MTS 6531 Manuel D'instructions page 16

en 16 | MTS 6531 | Operation
CAUTION – Cables - Overload
Possible risk of personal injury
¶
Make sure that any cable
connected to a high current
capable power source, such
as a 12-volt automotive bat-
tery, is in good condition. The
MTS 6531 is protected
by its own internal protection
device. A fault in the cable itself,
especially a power to ground
short, is capable of creating a
hazardous situation that can
cause personal injury.
CAUTION – Loopback Self-Test
Adapter - Overload
Possible risk of personal injury
¶
Do not apply power to
MTS 6531 through the
self-test adapter barrel connec-
tor unless the circuit is protec-
ted by a fuse, circuit breaker, or
current-limited power supply.
The fuse, circuit breaker, or cur-
rent-limited power supply must
be set to no more than 3 amps.
|
1 689 989 445 2019-07-01
5.6 Resetting the MTS 6531
1. Disconnect the voltage supply from the
MTS 6531.
2. Wait at least 20 seconds.
3. Reattach the voltage supply to the
MTS 6531.
5.7 Loopback self-test
With the self-test adapter you can conduct a lo-
opback self-test of the MTS 6531. using
the following steps.
1. Connect the diagnostic connection cable to
the MTS 6531.
2. Connect the self-test adapter to the vehicle
end of the diagnostic connection cable.
3. Power the self-test adapter either via a vehic-
le connection or a 12-V power adapter.
4. Start VCI Manager and connect the
MTS 6531.
5. In VCI Manager, choose "Help".
6. Press <Aktualisieren> (Update) to have the
search for available WLAN signals.
Robert Bosch GmbH