Bosch MTS 6531 Manuel D'instructions page 12

en 12 | MTS 6531 | Operation
5.3.3 Configuring the MTS 6531
using VCI Manager
In order to configure the MTS 6531
to communicate on your network, you must
connect the MTS 6531, via USB, to
a computer running the "VCI Manager" soft-
ware. The VCI Manager icon displayed on the
MTS 6531 will inform you of the commu-
nication method to be used when <Verbinden>
(Connect) is selected.
Icon Description
VCI Manager will connect to the
MTS 6531 via USB
VCI Manager will connect to the
MTS 6531 via Ethernet
VCI Manager will connect to the
MTS 6531 via Wireless
Wireless Point-to-Point is not set up. Use
a USB connecting cable to connect the
MTS 6531 to the computer to comple-
te setup.
Wireless adapters in the computer and in the
diagnostic device are incompatible with each
other.
VCI Manager is connected to the
MTS 6531
Use the following steps to configure your
MTS 6531.
1. Double-click the VCI Manager icon on your
desktop to launch the "VCI Manager" soft-
ware.
2. Select MTS 6531 in "VCI Explorer".
3. Click <Verbinden> (Connect) to connect to
the selected MTS 6531 over USB.
"
MTS 6531 is displayed with a green
checkmark on your display, indicating that your
"VCI Manager" software is in control of this
MTS 6531.
4. Click <Details anzeigen> (Show de-
tails) to see details about the selected
MTS 6531.
i
If your MTS 6531 is connected to
another networked computer, it will still be
detected by the VCI Manager, but will not be
available for connection.
i
If your MTS 6531 is connected via
USB to your computer, the VCI Manager
functions on all tabs are available; if your
MTS 6531 is not connected via
USB, the functions on the Network Setup
|
1 689 989 445 2019-07-01
and MTS 6531 Update tabs are not
available.
5.3.4 Checking the computer and
MTS 6531 software versions
i
Ensure, that the "VCI Manager" software
installed on your computer and the software
installed on the MTS 6531 have
matching software versions in order for
MTS 6531 to operate properly. Use
the following steps to check your software
versions.
1. Connect the MTS 6531 to your com-
puter using the USB connecting cable.
2. Double-click the VCI Manager icon on your
desktop to launch the "VCI Manager" soft-
ware.
3. Choose your MTS 6531 in "VCI Ex-
plorer".
4. Click <Verbinden> (Connect) to connect to
the selected MTS 6531 over USB.
5. Choose "Help" to see details about the soft-
ware versions.
Robert Bosch GmbH