System Control - Burkert 8285 El. COND Mode D'emploi

Overview of parameter setting
Menu selection
Select:
Return to meas
Parameter setting
Viewing level
Operator level
Administrator level (All Data) adm
Return

System control

Memory card (Option)
• Register logbook
• Register recorder
• Decimal separator
• Card full
• Formatting
Copy configuration
Parameter sets
• Load
• Save
Function control matrix
• Input OK2
• Left softkey
• Right softkey
Time/date
Point of meas description
Release of options
Software update
Logbook
Buffer table
Factory setting
Passcode entry
Parameter setting
25.6 °C
0.003 mS/cm
Activated from measuring mode: Press menu key to select
menu.
Select parameter setting using arrow keys, confirm with enter.
Administrator level
[enter]
Access to all functions, also passcode setting. Releasing or block-
Lingua
ing functions for access from the Operator level.
25.6 °C
Operator level
0.003 mS/cm
Access to all functions which have been released at the
(All Data) view
Administrator level. Blocked functions are displayed in gray
(Operation Data) opl
and cannot be edited.
Viewing level
Only display, no editing possible!
Menu only appears with SmartMedia Card inserted.
Make sure that it is a memory card,
not an update card.
Commercially available SmartMedia cards must be formatted
before they can be used as memory card.
The complete configuration of an analyzer can be written on a
SmartMedia card. This allows transferring all device settings to
other devices with identical equipment (exception: options and
passcodes).
2 parameter sets (A,B) are available in the analyzer.
The currently active parameter set is read on the display.
Parameter sets contain all settings except:
Sensor type, Options, System control settings
Up to 5 parameter sets (1, 2, 3, 4, 5) are available when a
SmartMedia card (Option) is used.
Selecting the control element for the following functions:
- Parameter set selection
- KI recorder (Start/Stop)
- Favorites menu (selected diagnostics functions)
- Unical (fully automated probe controller)
Selecting the display format, entry
Can be called up in the diagnostics menu.
A TAN is required to release an Option.
Software update from SmartMedia card (update card)
Selecting events to be recorded
Entering own buffer set for automatic calibration
Resetting all parameters to factory setting
Editing the passcodes
77