Configuring A Calculation Block - Burkert 8285 El. COND Mode D'emploi

Configuring a Calculation Block

Menu selection: Parameter setting/System control/Select Calculation Block
Setting the process variable to be calculated
Menu Display
Parameter setting (Administrator)
System control
Module 8285 FRONT
Module 8285 BASE
Module 8285 El. COND
Module 8285 El. COND
+
Calc Cond/Cond
Return
+ Calc Cond/Cond (Administrator)
Difference S/cm
Difference °C
Difference pH
Messages
Return
+ Messages (Administrator)
Messages Conductivity
Messages Temperature
Messages pH value
Return
+ Messages Conductivity (Admin.)
Monitoring
Failure Limit Lo
Warning Limit Lo
Warning Limit Hi
Failure Limit Hi
Return
52
Configuring a
Calculation Block
Select Calculation Block
40.00 µS/cm
25.6 °C
•
•
•
40.00 µS/cm
Depending on the modules installed,
25.6 °C
the possible combinations for
Calculation Blocks are offered.
–
Off
–
40.00 µS/cm
Messages
25.6 °C
You can activate messages for the
selected variables.
Variables which have been set as
"Off" cannot be processed further.
40.00 µS/cm
The measured values which shall
25.6 °C
release a message are set using the
Variable limits
arrow keys
20.00 µS/cm
(left/right: select position, up/down:
30.00 µS/cm
80.00 µS/cm
edit number). Confirm with enter.
100.0 µS/cm
Activating parameter setting
System control
Select module
8285