Burkert 8285 El. COND Mode D'emploi page 14

Short description: FRONT module
8285
View into the open device (FRONT)
Slot for SmartMedia card
• Data recording
The SmartMedia card expands the
measurement recorder capacity to
> 50000 records.
• Exchange of parameter sets
5 parameter sets can be stored on
the SmartMedia card, 2 of them
can be loaded to the analyzer and
switched by remote control.
Parameter sets can be transmitted
from one analyzer to the other.
• Function expansions are possible
with additional software modules,
which are released using transaction
numbers (TAN).
• Software updates
Terminal plates
of "hidden" modules
Each module comes with an adhesive
label containing the contact assignments.
This label should be sticked to the inner
side of the front
(as shown). Then, the terminal assign-
ments remain visible even if further
modules are inserted.
14
Replacing the front module
Pull off power cord and ground wire.
To separate the FRONT module from
the BASE module, turn the retaining
screws of the pivot hinge by 90°.
The circumferential sealing
guarantees IP 65 protection and allows spray
cleaning / disinfection.
Caution! Keep clean!
8285