Machine Description And Intended Use - Fort VISION Manuel D'utilisation Et D'entretien

Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
7.2 MACHINE DESCRIPTION AND
INTENDED USE
The ATOMIZER group, described in this «Section 7», is a
motorized atomizer, which uses an autonomous motive force
and which can be installed only on the VISION multifunction
machine and on the MINITRANSPORTER manufactured by
FORT and designed to receive and operate this interchange-
able equipment (1 Fig. 21). The atomizer works by receiving
motion directly from an auxiliary engine (2 Fig. 21), completely
independent of the driving force of the machine, which ma-
kes both the diaphragm pump work (2 Fig. 23) that the fan if
inserted.
The motorized ATOMIZER group can be installed and unin-
stalled, with the appropriate equipment and precautions by
suitably trained personnel (see «Chapter 7.4 Installation»).
The motorized ATOMIZER installed on the VISION multi-
function machine is an interchangeable piece of equipment
and therefore must be considered subject to the Directive
2006/42/EC as stated in «Art. 2, section b), on interchangea-
ble equipment: a device that,
3
Fig. 23 - Vertical bar atomizer connection to the VISION multifunction machine
1) Fan drive motor group. - 2) Fan-driven diaphragm pump. - 3) Support legs (4) on the floor of the group detached from the
machine. - 4) Third upper point adjustment tie rod hooked to the machine. - 5) Spark plug with locking snap pin on the upper
third point. - 6) Arms (#2) supporting lower points. - 7) Jack with snap pin locking two lower points. - 8) Fan engine start handle.
66
the machine or tractor by the Operator in order to modify its
function or provide a new function, insofar as this equipment
is not a tool».
The ATOMIZER is therefore considered to be a machine
and as such is «CE» marked in compliance with the Euro-
pean Union standards set out in Directives 2006/42/EC and
2004/108/EC, as reported in the declaration of conformity of
which each machine is accompanied and reported on page 5
in the facsimile.
The below regulations have also been applied for the manu-
facture of the machine:
- UNI EN ISO 12100:2010 - Safety of machinery - General
principles of design - Risk assessment and risk reduction
- UNI EN ISO 13857:2008 - Safety of machinery - Safety
rules to prevent the reaching of dangerous areas with the
upper and lower limbs.
- UNI EN 349:2008 - Safety of machinery - Minimum space to
avoid crushing of body parts.
- UNI EN ISO 4254-6:2010 - Agricultural machinery - Safety -
Part 6: Sprayers and liquid fertilizer distributors.
1
2
6
8
5
4
7