Set Aside; Scrapping Of The Machine; Spare Parts; Rules For Orders - Fort VISION Manuel D'utilisation Et D'entretien

5.4

SET ASIDE

If a long period of machine inactivity is expected, it is neces-
sary to:
- Accurately clean the entire machine from all traces of dirt.
- Suck the pipes and recycle water with protective antifreeze.
- Fully tighten all pipe connections.
- Check the correct tightening of the screws.
- Check and replace any damaged or worn parts.
- Apply any rusted or abraded areas with a coat of anti-rust
paint.
- Lubricate/grease all parts subject to wear.
- Cover the machine with a cloth, and place it indoors, away
from bad weather, frost and humidity.
If these works are carried out with care, the User will find
the equipment in perfect condition when work is resu-
med. Finally, remember that the Manufacturer is always
available for any assistance and spare parts needs.
5.5

SCRAPPING OF THE MACHINE

If you were to decide to scrap the machine, you will have to
proceed to the separation of its components in homogeneous
parts that will be disposed of separately in compliance with the
local regulations regarding the disposal of waste.
The exhausted oil must be appropriately recovered and must
not be dispersed in the environment, since, according to the
legal standards in force, it is classified as hazardous waste,
and as such must be given to the appropriate collection cen-
ters.
Dispose of exhausted lubricants and liquids and any various
detergents, in appropriate authorized collection facilities.
WARNING: Avoid touching the damaged pipes
without protective gloves due to the risk of cor-
rosion and irritation.
Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
5.6

SPARE PARTS

USE ONLY ORIGINAL SPARE PARTS.

5.6.1 RULES FOR ORDERS

To request spare parts for the machine, contact your local de-
aler. If necessary, if the Dealer does not have it, contact the
Manufacturer.
FORT Srl Unipersonale
36040 SOSSANO (Vicenza) Italy - Via Seccalegno, 29
Tel. (+39) 0444 788000 - Fax (+39) 0444 788020
email: info@fort-it.com
accompanying the request with the following data:
- Model, serial number and year of manufacture of the ma-
chine. These data are stamped on the identification plate of
each individual machine.
- Code number of the requested part detectable from the ca-
talog of spare parts.
- Detail description and required quantity.
- Shipping method. If this item is not specified, FORT Srl Uni-
personale, although dedicating special care to this service,
is not liable for any shipping delays due to force majeure.
Shipping costs are always borne by the recipient.
The goods travel at the customer's risk and danger even if
sold free of fate.
FINALLY, PLEASE REMEMBER THAT THE MANUFACTU-
RER IS ALWAYS AVAILABLE FOR ANY NEED FOR ASSI-
STANCE AND/OR SPARE PARTS.
59