Pressure Regulator - Fort VISION Manuel D'utilisation Et D'entretien

Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
3
Fig. 9
1) Suction filter - 2) Level graduated scale. - 3) Agitator
(inside the tank)
filtranti (1 Fig. 9) di circa 50 mesh e con foro equivalente da
0.4 to 0.35 mm.
The correct operation of the filter allows the atomizer to work
well.
It is necessary to periodically check the cleaning of the filtering
cartridge; this check should be intensified if the introduced li-
6
7
3
8
9
4
Fig. 10 - Pressure regulator
52
2
1
2
1
5
quid has impurities.
Before removing the filter cap, make sure it is isolated from the
pipe by unscrewing the appropriate rear valve. After washing
the cartridge, refit the cover remembering to reconnect it to the
circuit by acting on the valves previously described in reverse.
4.1.4 PRESSURE REGULATOR (Fig. 10)
The pressure regulator controls all the most important sprea-
ding functions, so a good knowledge of its functions facilitates
the work and makes it more precise.
The working pressure and the maximum pressure of the pul-
verizer are determined by the pressure regulator that also pro-
tects the circuit from overpressure in any working condition.
The references are related to Fig. 10.
1) «Open» ON-OFF control lever for sending the liquid to the
circuit of use; «Closed/BY-PASS» control lever for dischar-
ging it into the tank.
2) Manual pressure adjustment knob. Drain excess liquid into
the tank when the set pressure is reached.
3) Right section opening/closing tap.
4) Left section opening/closing tap.
5) Pressure gauge: it shows the working pressure.
6) Supply line from the pump.
7) Drain pipe to the tank.
8) Jets section delivery pipe.
9) Auxiliary delivery pipe
2
3
1
4
Fig. 11 - Fan
2
3
4