Start Of The Treatment - Fort VISION Manuel D'utilisation Et D'entretien

Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
1
2
Fig. 14 - Flow opening/closing taps
geneous.
- Temporarily interrupt the work, shake the mixture constantly
until treatment is resumed. If the use is suspended, before
resuming, check the cleaning of the filter cartridge and sha-
ke the mixture left in the tank.
WARNING: At the end of the works necessary to
carry out the intervention, the places of deposit
and/or storage must be left in the conditions re-
quired to carry out their functions of prevention
and protection.
4.3 START OF TREATMENT
WARNING: Before starting the machine, keep
people or animals away and never leave them
unattended during preparation.
FOR ALL RUNNING OPERATIONS OF THE MACHINE,
ALWAYS REFER TO THE INSTRUCTION BOOKLET ATTA-
CHED TO THE SAME.
- Through the knob (1 Fig. 15) lock the rear stabilizer roller
supports.
- Rotate the two taps (1 and 2 Fig. 14). This operation opens
the spraying circuit.
- Adjust the inclination of the upper deflectors (3 Fig. 11),
using the two knobs (2 Fig. 11) to the desired position.
- Position the spray nozzles (1 Fig. 7), orienting them accor-
ding to your needs. The nozzles have two turns to allow a
different adjustment of the outlet jet.
56
1
2
Fig. 15 - Fan height adjustment
- The jet closes positioning the nozzles horizontally (2 Fig. 7).
After positioning the machine on a leveled surface, remove
any extraneous parts in the operating range and after fol-
lowing the instructions in paragraph «4.2 Before use» and,
referring to the instructions for use of the machine, proceed
with the start-up.
1) Sit in the driver's seat while seated and fasten the seat
belt.
2) Bring the machine into the work area.
3) Before starting distribution, let the power take-off idle and
adjust the pressure with the pressure regulator (2 Fig. 10).
4) Depending on what is to be treated and/or distributed, cal-
culations must be made considering the paragraph «4.2.6
Criteria for adjusting and choosing water volumes».
5) It is important to pay the utmost attention to the diameter
of the holes and the pressures to be used, as well as the
speed of advancement.
6) Working clockwise on the knob (2 Fig. 10), the manometer
(5 Fig. 10) will indicate an increase in pressure, turning it
counterclockwise the gauge will show a decrease.
7) Pay attention to treatments, near homes, waterways, ro-
ads or paths for public use.
8) Check that the fan speed is the desired one.