General Information; Assembly Works - Fort VISION Manuel D'utilisation Et D'entretien

Installing the atomizer group on the VISION multifunction machine
6.1

GENERAL INFORMATION

This Section contains information, instructions and what is
deemed necessary for the assembly of the various compo-
nents, supplied loose, with the VISION multifunction machine
manufactured by the «FORT» Company based in Sossano
(Vicenza) Italy, in order to form a single machine called Self-
Propelled Atomizer.
WARNING: It is strongly recommended that as-
sembly works are carried out by competent and
trained personnel for this purpose. The company
«FORT» declines any and all responsibility for
any direct or indirect damage or accidents that
may occur during assembly works. The company
«FORT» also is not responsible for any malfun-
ctions that may occur due to installation works
carried out with superficiality, incompetence, by
inexperienced personnel, or when not following
correctly the instructions given in this manual.
1
Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
SECTION 6
The groups that make up the atomizer group can be identified
in (Fig. 17):
1) Fan group;
2) Product tank group;
3) Pressure regulator control group.
6.2
The VISION multifunction machine must be positioned with
the engine off, on level ground, well-locked, inside an equip-
ped workshop. The seat must be as shown in the figure so
that the engine is in front of the machine. If this is not the case,
read the instruction manual of the machine under «Reversi-
bility» and turn the seat to match the configuration shown in
Figure 17: front product tank, rear fan.
The VISION multifunction machine is a reversible driving
machine, which means that it is possible to rotate the
driver's seat and reverse. During operation, it is absolu-
tely forbidden to rotate the seat, the atomizer tank must
always be in the front position and the fan in the rear po-
sition.
3
Fig. 17 - Groups that make up the atomizer

ASSEMBLY WORKS

2
61