Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
4.1
MAIN COMPONENTS
4.1.1 NOZZLES
he nozzles installed in the atomizer are of the double head type
(Fig. 7). It is possible to install other types of nozzles by consul-
ting the Technical Dept. of the Manufacturer. The nozzles are
12 (6 per side), are equipped with an anti-drip membrane and
the manufacture material is brass for pressures up to 40 bars.
The jets normally used have two positions:
1) SPRAYING PHASE: if the nozzle is facing the outside of
the fan group and is parallel to the anti-drip valve (1 Fig. 7);
2) CLOSING PHASE: if the nozzle is turned at 90° and faces
the inside of the fan group (2 Fig. 7);
The nozzles are extremely important to obtain a correct distri-
bution on the vegetation to be treated. Poor quality or worn out
nozzles tend to create unevenly treated strips; use outside of the
intended scope affects the accuracy and durability of the nozzle.
1
Fig. 7 - Ugelli
Use and maintenance ATOMIZER ON VISION MULTIFUNCTION MACHINE
SECTION 4
Use
2
NOZZLE CAPACITY TABLE
Pressione
Lilla Marrone
5,00
0,37
0,48
5,50
0,39
0,50
6,00
0,40
0,53
7,00
0,44
0,57
8,00
0,47
0,61
9,00
0,49
0,64
10,00
0,52
0,68
11,00
0,55
0,71
12,00
0,57
0,74
13,00
0,59
0,77
14,00
0,62
0,80
16,00
0,66
0,86
18,00
0,70
0,91
20,00
0,74
0,96
4.1.2
MEMBRANE PUMP (Fig. 8)
For the use of the diaphragm pump, carefully follow the en-
closed handbook supplied by the Manufacturer. The pump
can be identified by the plate applied on the pump, which also
shows the main pressure and flow rate data.
Normally the pumps must not exceed the number of revolu-
tions specified by the Manufacturer; a higher number of revo-
lutions does not improve performance but risks compromising
its duration and safety.
On the pump there is a safety valve suitably calibrated to pre-
vent overpressure.
Do not tamper with this valve for any reason or obstruct the
pipes connected to it in any way.
4.1.3
SUCTION FILTER (Fig. 9)
L'atomizzatore è dotato del filtro d'aspirazione con cartucce
Fig. 8 - Pompa a membrana
Giallo Arancione Rosso
0,75
0,98
1,40
0,79
1,03
1,47
0,82
1,08
1,53
0,89
1,16
1,65
0,95
1,24
1,77
1,00
1,32
1,87
1,06
1,39
1,98
1,11
1,46
2,07
1,16
1,52
2,16
1,21
1,59
2,25
1,25
1,65
2,34
1,34
1,76
2,50
1,42
1,87
2,65
1,50
1,97
2,8
51
Publicité
Chapitres
Table des Matières
Dépannage
