Introduction; Device Description - Scheppach HS111 Traduction Des Instructions D'origine

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschinen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much enjoyment
and success.
Note:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by the
product that occurs due to:
• Improper handling
• Non-compliance of the operating instructions
• Repairs by third parties, by not authorized service
technicians
• Installation and replacement of non-original spare
parts
• Application other than specified
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113
Please observe the following:
Read through the complete text in the operating in-
structions before installing and commissioning the
device.
The operating instructions are intended to help the
user to become familiar with the machine and take ad-
vantage of its application possibilities in accordance
with the recommendations.
The operating instructions contain important informa-
tion on how to operate the machine safely, profession-
ally and economically, how to avoid danger, costly
repairs, reduce downtimes and how to increase relia-
bility and service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country.
Keep the operating instructions package with the
machine at all times and store it in a plastic cover to
protect it from dirt and moisture. Read the instruction
manual each time before operating the machine and
carefully follow its information.
The machine can only be operated by persons who
were instructed concerning the operation of the ma-
chine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
30 | GB
In addition to the safety instructions contained in this op-
erating manual and the specific regulations of your coun-
try, the technical rules generally accepted for the oper-
ation of machines of the same type must be observed.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions and
the safety information.
2. Device description (fig. 1 - 3, 8, 9,
12, 13, 16, 18 ,19, 24)
1. Parallel stop
1a. Stop rail
1b. Wing nut
1c. Coach bolt
1d. Philips screw
2. Saw table
3. Table extension
4. Extraction hose
5. Table inlay
5a. Countersunk head screw
6. Riving knife
6a. Fixing screw
7. Saw blade
7a. Inner saw blade flange
7b. Outer saw blade flange
7c. Drive shaft
7d. Fixing nut
7e. Reducing ring
8. Saw blade guard
9. Transverse stop
9a. Stop rail
9b. Wing nut
9c. Locking handle
10. Table width extensions
10a. Table width extension right
10b. Table width extension left
11. On/off switch
12. Cover cap on/off switch
13. Overload switch
14. Locking lever
15. Crank wheel
16. Scale
17. Centre strut long
18. Leg
19. Rubber foot
20. Centre strut short
21. Extraction port
22. Push stick
23. Table support long
24. Table support medium
25. Table support short
26. Scale
27. Wooden push block (not included in the scope
of delivery)
28. Guide rail
29. Sight glass
30. Groove
www.scheppach.com