Activating And Deactivating An Attached End Device On A Wireless Switching Module - Conrad 75 13 64 Notice D'emploi

Second step: Programming the alarm system to the wireless switching module.
Proceed as follows to programme the alarm system to the wireless switching module:
Step Action
1 Press and hold the learn button on
the Control Module until ist LED
starts to flash.
2 Press and hold the 6,7,8,9 or 0
button for approx 5 seconds
Depending on which memory position the wireless switching module was programmed to in the first step
(1, 2, 3, 4 or 5), the corresponding correct button must be pressed in the second step. Below is an
overview of which memory position (1, 2, 3, 4, 5 - first programming step) belongs to which programming
buttons (6, 7, 8, 9, 0 – second programming step).
Memory position
1
2
3
4
5
14.6.2 Activating and Deactivating an Attached End Device on a Wire-
less Switching Module
Please proceed as follows to activate a wireless switching module:
• Press the button (6, 7, 8, 9 or 0) in the memory position of the wireless switching module you wish to
activate.
• Your hear a voice message informing you that the corresponding wireless switching module is now
being activated. At the same time the „PROG" LED (9) flashes - the flashing indicates to you that the
alarm system is sending a signal to the wireless switching module.
• As soon as the receiver in the wireless switching module receives the signal, you hear a message that
the activation of the wireless switching module has been accepted.
Please proceed as follows to deactivate a wireless switching module:
• Press the button (1, 2, 3, 4 or 5) of the memory position of the wireless switching module you wish to
deactivate.
84
Function
You enter the programming
mode.
Transmit an ON signal for the
selected device from the Control [Device X on] indicating you have
Panel to the Control Module.
Programming button
6
7
8
9
0
Note
LED on the Control Module will
flash indicating it is in learn
mode.
After [X] is entered, you will hear
transmitted an ON signal for
device X, where X is the Control
Module Location. The LED on the
Control Module should be off,
indicating it has learned the sig-
nal, you may now release the
learn button and the LED will stay
on again.