Programming In A Remote Control - Conrad 75 13 64 Notice D'emploi

Overview table:
This illustrates which button must be pressed in step 4 or 5 of the table above:
Deactivate zone as „bypass zone":
Zone 1 Button 1
Zone 2 Button 2
Zone 3 Button 3
Zone 4 Button 4
Zone 5 Button 5

14.4 Programming in a Remote Control

You can programme additional remote controls to the alarm system.
A maximum of five remote controls can be programmed to the system.
In the interest of organisational clarity the remote controls should be programmed to the zones 6, 7, 8, 9
or 0.
Proceed as follows to programme additional remote controls to the alarm system:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 4
4 Press the button 6, 7, 8, 9 or 0
(depending on which memory
position you wish to programme
the remote control to).
5 Press any key on the remote control
** Explanation of „zone status LEDs" (1) from step 3 in the table above:
„Zone status LED" (1)
Does not light up
Flashes twice
Flashes once
Flashes once and then twice
78
Function
You enter the programming
mode.
You enter the programming
mode for programming in a
new remote control.
The settings are saved and the
programming mode for
programming in new remote
controls is exited.
Explanation
No remote control has been programmed to this zone yet.
A remote control has already been programmed to this zone.
An (optionally available) wireless switching module has already been pro-
grammed to this zone. A remote control can, however, still be programmed to this
zone. The programmed wireless switching module will „not" be deleted in the
process.
A wireless switching module and a remote control have both already been pro-
grammed to this zone. If you add another remote control to this zone, the previ-
ous remote will be overwritten.
Activate zone as „bypass zone":
Button 6
Button 7
Button 8
Button 9
Button 0
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash.
** See following table for further
explanation
Please also note the following
overview table.