Deleting Sensors; Operation Of And Programming Of A Wireless Switching Module; Programming Of A Wireless Switching Module - Conrad 75 13 64 Notice D'emploi

14.5.3 Deleting Sensors

Proceed as follows to delete sensors from the memory in the alarm control centre:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 9
4 Press the button 1, 2, 3, 4, 5, 6, 7,
8, 9 or 0, depending on the memory
postion you wish to choose to delete
a sensor.

14.6 Operation of and Programming of a Wireless Switching Module

The optionally available wireless switching module can be used to activate or deactivate attached end
devices. You can programme up to five wireless switching modules to the alarm system.
There are three methods by which you can control the wireless switching module.
a) Use the alarm system to control the wireless switching module.
b) If you are not at home you can use the telephone to control the wireless switching module. (please
note the Chapter „12 Operating the Alarm System by Telephone")
c) Allocate an event trigger (please note the Chapter „14.7 Event Triggering")
Wireless switching modules should be saved to memory positions 1, 2, 3, 4 or 5.

14.6.1 Programming of a Wireless Switching Module

Both the alarm control centre and a wireless switching module contain a transmitter and a receiver. Thus
the programming of a wireless switching module requires two programming steps.
First step:
Second step:
82
Programming the wireless switching module to the alarm system.
The buttons 1, 2, 3, 4 or 5 serve the programming of the switching module to the
alarm system (see the following programming instructions).
Programming the alarm system to the wireless switching module.
The buttons 6, 7, 8, 9 or 0 serve the programming of the alarm system to the
wireless switching module (see the following programming instructions).
Function
You enter the programming
mode.
You enter the programming
mode for deleting programmed
sensors.
A voice message confirms
successful deletion.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash.
** Please see the table regarding
the „meaning of zone status
LEDs" in Chapter „14.5.2
Programming in Sensors" for
further explanation.
The deletion is saved and the
programming mode for deleting
programmed sensors is exited.