Programming In Sensors - Conrad 75 13 64 Notice D'emploi

14.5.2 Programming in Sensors

The following table provides you with an overview of the sensors which can be programmed to which
zones. At the same time you see which buttons (these correspond to the memory position) need to be
pressed in order to programme the sensor to the desired memory position.
Sensor 1
Zone 1 Button 1
Zone 2 Button 2
Zone 3 Button 3
Zone 4 Button 4
Zone 5 Button 5
To programme new sensors, proceed as follows:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 3
4 Press the button 1, 2, 3, 4, 5, 6, 7,
8, 9 or 0, depending on the memory
postion you wish to use.
5 Activate the sensor which you would
like to programme in.
** Explanation of „zone status LEDs" (1) from step 3 in the table above:
„Zone status LED" (1)
Does not light up
Flashes twice
Flashes once
Flashes once and then twice
Sensor 2
Button 6
Button 7
Button 8
Button 9
Button 0
Function
You enter the programming
mode.
You enter the programming
mode for programming new
sensors.
A voice message confirms
successful programming.
Explanation
No wireless sensor has been programmed to this zone yet.
Sensor 1 has been programmed to this zone.
Sensor 2 has been programmed to this zone.
Sensor 1 and sensor 2 have been programmed to this zone.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
As soon as you enter the
programming mode, the „zone
status LEDs" (1) light up or flash.
** See following table for further
explanation.
To choose the correct memory
position, note the table above.
The settings are saved and the
programming mode for
programming in new sensors is
exited.
81