Reset Factory Settings - Conrad 75 13 64 Notice D'emploi

Proceed as follows to programme in an event trigger:
Step Action
1 Press „PROG" (12).
2 Enter the four digit master code
3 Press button 7
4 Press the button 1, 2, 3, 4 or 5 to
generally deactivate an event trigger.
Press the button 6, 7, 8, 9, or 0 to
carry out activation or deactivation
programming. You will see by the
corresponding „zone status LED" 1
whether an activation (zone status
LED lit) or a deactivation
(zone status LED flashes) has been
allocated.
5 Press „PROG" (12).

15. Reset factory settings

Note, that all sensors are deleted if a RESET to factory settings is carried out. Addi-
tionally, all customised settings are deleted. The alarm system has to be reprogram-
med completely. Sensors, radio remote control and other equipment has to be retrai-
ned. After performing a factory reset, the security codes are as described in section
"9. Security codes programming".
The reset the alarm system into factory state, follow these steps:
• Remove the battery.
• Disconnect the wall power supply from the main current outlet.
• Open the lid of the battery compartment.
• Press and keep pressed the keys 1 + 4 + 7 simultaneously. Plug the wall power supply into the main
socket while keeping the keys pressed.
• All LEDs will flash. A beep will be audible to confirm the successful RESET.
• Stop pressing the keys. Factory settings are reset.
Function
You enter the programming
mode.
You enter the programming
mode for programming in an
event trigger.
The settings are saved and the
programming mode for
programming an event trigger
is exited.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
The „PROG" LED (9) goes out.
87