Deleting A Wireless Switching Module - Conrad 75 13 64 Notice D'emploi

• Your hear a voice message informing you that the corresponding wireless switching module is now
being deactivated. At the same time the „PROG" LED (9) flashes - the flashing indicates to you that the
alarm system is sending a signal to the wireless switching module.
• As soon as the receiver in the wireless switching module receives the signal, you hear a message that
the deactivation of the wireless switching module has been accepted.

14.6.3 Deleting a Wireless Switching Module

Two programming steps are required to delete a wireless switching module from the alarm system, as is
the case for programming (Chapter 14.6.1 Programming of a Wireless Switching Module)
First step: Deleting the wireless switching module from the alarm system memory
Second step: Deleting the memory of the wireless switching module
First step:Proceed as follows to delete the wireless switching module from the alarm system memory:
Step Action
1 Press „PROG" (12).
2 Enter your four-digit master code.
After entering your four-digit master
code, press the key 0 on the alarm
system ".
3 Press the button 1, 2, 3, 4 or 5
(depending on which memory
position you wish to delete).
** Explanation of „zone status LEDs" (1) from step 3 in the table above:
„Zone status LED" (1)
Does not light up
Flashes twice
Flashes once
Flashes once and then twice
Function
You enter the programming
mode.
This sends a signal from the
alarm system to the wireless
switching module. Please note
the table below to ensure you
interpret the „zone status LEDs"
(1) correctly.
Explanation
No wireless switching module has been programmed to this memory position yet.
A remote control has already been programmed to this memory position.
This is „not" a wireless switching module! Do not accidentally delete this remote con-
trol!
A wireless switching module has already been programmed to this memory position.
You can delete this wireless switching module.
A wireless switching module and a remote control have both already been pro-
grammed to this zone. You can select this zone to delete the wireless switching
module.
Note
3 x a short beep confirms entry of
the correct code. 1 x long beep
indicates incorrect code entry.
After you have chosen the
corresponding memory position,
three beep tones are emitted
and a voice message is
emitted.
85