Cleaning And Care - DS Produkte A02 Mode D'emploi

completing the boiling process; if it is fi lled past the MAX mark, water may spray out during
the boiling process.
3. Close the lid and place the kettle on the base.
4. Set the On/Off switch of the kettle to position I (ON). The device will turn on and the power
light will illuminate. You can interrupt the boiling process at any time by pushing the On/Off
switch upwards.
5. The kettle automatically deactivates once the water has boiled. The On/Off switch is set to
position 0 (OFF).
6. Take the kettle off of the base and carefully pour the water into a suitable container.
Let the device cool off before you add and boil cold water again.
If not in use, the kettle may be stored on the base. However, be sure to pull the mains plug out
of the socket.
If you accidentally use the kettle without any water, the device switches off automatical-
ly. In this case, push the On/Off switch upwards and let the kettle cool off.

Cleaning and care

ATTENTION!
❐ Never submerge the device, the mains cable, and the plug in water or other liquids.
❐ When cleaning, do not use any aggressive, scouring or toxic cleaners.
❐ Prior to each cleaning, pull the plug out of the socket.
❐ Allow the device to cool off before cleaning.
• Check the mains cord for damages on a regular basis.
• Wipe the device off from the outside with a clean, damp cloth.
• Keep the device in a ready-to-operate state. You should remove limescale from water on a
regular basis and according to the water quality in your region and the frequency of use. Use
a decalcifi er for this. Follow the instructions of the decalcifi er when decalcifying the kettle.
15