Care And Decalcifying - DS Produkte Z 03901 Mode D'emploi

6. Close the water tank cover.
7. Place the thermo cup (without the cover!) or the ceramic cup under the coffee spout.
IMPORTANT: Place a cup or similar under the coffee spout before you connect
the device to a socket as the device will begin with the brewing process right
away if the On/Off button switch has been pushed before the device was con-
nected and the device is connected to a socket.
8. Connect the device to a properly installed socket.
9. Push the On/Off switch to switch the coffee maker on. The On/Off switch will illumi-
nate and the brewing process will begin immediately.
10. The brewing process is complete when no more coffee fl ows into the coffee cup.
The device automatically deactivates after the brewing process. The On/Off button
will go out once the device is switched off.
11. Remove the thermo cup / ceramic cup and screw the cover onto the thermo cup. The
lid has a drinking aperture. Simply push the lid cover forward or backward to open
or close the drinking aperture.
12. After use, clean the device as described in the chapter "Care and decalcifying".

Care and decalcifying

ATTENTION!
■ The permanent fi lter and the permanent fi lter holder are hot after use! Let them cool
off before removing them for cleaning.
■ Never submerge the device, the mains cord or the plug in water.
■ Prior to each cleaning, pull the plug out of the socket.
■ When cleaning, do not use any corrosive or abrasive cleaners. They could damage
the surface.
1. Ensure that the device is switched off and disconnected from the power supply!
2. Take the permanent fi lter out of the fi lter compartment and dispose of the used cof-
fee pad / coffee grounds.
3. Clean the permanent fi lter, permanent fi lter holder, the ceramic and thermo cup with
hot water and, if necessary, a small amount of mild detergent.
4. Then thoroughly dry all parts.
5. Place the permanent fi lter and the permanent fi lter holder back in the coffee maker
once they are completely dry.
6. When needed, wipe off the coffee maker with a damp cloth and dry it with a dry cloth.
Decalcifying
You should decalcify the device if water is only circulating very slowly or the device is
making more noise than usual during the brewing process. Use a commercially-availa-
ble decalcifi er for coffee makers for decalcifi cation.
1. Fill the water tank with a mixture of water and decalcifi er and turn the device on.
Consult the decalcifi er instruction manual to determine the correct ratio of water to
decalcifi er.
19 EN