Cleaning And Storage - DS Produkte HS-R10A Mode D'emploi

If the central spit (4) cannot rotate freely, you should dismantle the device and
assemble it again. Make sure that the retaining bracket (1) is fi tted correctly to the
cog of the central spit (2).
7. Switch the device off by moving the On/Off switch (6) to Position 0 (Off).
During operation the handles of the skewers (3) become hot! Allow them to cool
down before you remove the skewers (3). We recommend that you wear oven
gloves when handling the device.
8. Disconnect the device from the mains power after use and allow it to cool down
before you clean it.

Cleaning and Storage

CAUTION!
■ Before cleaning the device, always remove the mains plug from the mains socket and
allow the device to cool down.
■ The central spit with the skewer plate, the skewers and the fat collecting tray are
suitable for the dishwasher.
■ Do not spray cleaning agents directly onto the device.
■ CAUTION The device, the cable and the plug should never be immersed in water or
other liquids. There is the risk of an electric shock.
■ Do not use corrosive or abrasive cleaning agents, rough sponges or knives to clean
the device. These could damage the surfaces.
■ Never wind the cable tightly around the device when you put it away.
1. Make sure that the device has completely cooled down, is switched off and has been
disconnected from the mains power!
2. Dismantle the device (see the "Assembly" chapter).
3. Clean the device with a soft cloth and a little mild washing-up liquid.
4. Clean the accessory parts with a little washing-up liquid and warm water.
Over time residues of fat can burn into the heat shield (10). This leads to
discolouration, but does not affect the performance of the device.
5. Dry the device and the accessories thoroughly before you store them all away.
6. Store the device in a dry place that is protected from sunlight and is not accessible
to children and animals.
21 EN