Assembly - DS Produkte HS-R10A Mode D'emploi

EN
4. Place the device on a dry, heat-resistant, fl at surface with suffi cient clearance on all
sides and above (around 30 cm).
5. Insert the plug into a properly installed socket.
6. Switch the device on by moving the On/Off switch (6) to Position I (On). The operating
lamp lights up. Allow the device to heat up for around 5 minutes to remove any
production residues.
7. Switch the device off by moving the On/Off switch (6) to Position 0 (Off).
8. Remove the plug from the socket.
9. Allow the device to cool down and then clean it again.

Assembly

CAUTION!
■ CAUTION Danger of injury! The skewers have sharp points. Be careful when you
use or clean them.
1. Place the device on a dry, heat-resistant, fl at surface with suffi cient clearance on all
sides and above (around 30 cm).
18
2. Place the fat collecting tray (7) in the hub of the central spit
in the base of the device.
3. Place the heat shield (10) between the heating element (8)
and the rear wall of the device.