DS Produkte HS-R10A Mode D'emploi page 16

EN
■
In the event of a fi re:
– It is essential to remove the mains plug immediately.
– Hot fat / oil may catch fi re if it is overheated. Do not extinguish burning fat / oil with
water, but smother the fl ames with a fi re blanket or similar cloth or extinguish a fat
fi re with a fi re extinguisher which is capable of extinguishing fi res involving cooking
fat!
– Do NOT use water to extinguish the fi re as the steam can pose an additional risk
of scalding.
– Dispose of the device correctly.
■ Do not place any combustible materials, such as cardboard, plastic, paper or candles,
on or in the device.
■ Do not place food that is wrapped in cling fi lm, plastic bags or aluminium foil in or on
the device.
■ Always check the device for damage before putting it into operation. Only use it if the
device, mains cable and plug have no signs of damage!
Avoiding Damage to Material, Property and the Device
■ Always place the device on a dry, fl at and fi rm surface that is not sensitive to heat.
■ Maintain suffi cient clearance from other sources of heat such as hotplates or stoves
in order to avoid damage to the device.
■ Do not expose the device to extreme temperatures, strong temperature fl uctuations,
direct sunlight or moisture.
■ Do not drop the device or allow it to be knocked violently.
■ Never leave the device unsupervised during operation!
■ The device must not be moved during operation.
■ Do not pull or carry the device by the mains cable.
■ Do not wrap the cable around the device.
■ Make sure that the mains cable is not squashed, bent or laid over sharp edges and
does not come into contact with hot surfaces.
■ Only the accessory parts supplied by the manufacturer should be used. If accessory
parts which are not authorised by the manufacturer are used, all warranty and
guarantee claims are void.
■ Do not use any caustic or abrasive cleaning agents to clean the device. These can
damage the surface.
Notes on Hygiene
■ The device should be cleaned before you use it for the fi rst time. It is possible that
production residues may still be adhering to the surfaces. It is essential that you
follow the cleaning instructions in the "Before Initial Use" chapter.
■ Clean the device after each use to prevent germ formation (see the "Cleaning and
Storage" chapter).
■ Keep the device clean.
16