Inserting / Changing Batteries; Technical Data; Cleaning And Storage - DS Produkte 01185 Guide Rapide

EN

Inserting / Changing Batteries

CAUTION!
■ When the battery compartment is opened, the can
opener may be activated by accidentally pressing
the On / Off button. You should therefore always
place your fi ngers a safe distance away from the
cutting blade!
2 x 1.5 V batteries of the AA type are also required.
These are not supplied with the product.
3. Slide the battery compartment cover shut again. You
should feel and hear it click into place.
Use
• If the can which is to be opened has an open-
ing ring pull, use the can opener to open the
bottom of the can and not the top.
• The cutting blade (4) does not work if it is not
placed correctly on the edge of the can.
• The can opener cuts on the seam on the can
lid. This ensures that no sharp cutting edges
are produced!
• CAUTION! Only use the can opener with the
protective cap (5)!
2. Press the On / Off button (1). The motor starts to oper-
ate and the cutting blade (4) extends. The can opener
automatically cuts open the lid. It is not necessary to
guide the can opener with your hand.
3. Once the cutting blade (4) has moved all the way
round the edge of the can, the motor can be switched
off. To do this, press the On / Off button (1) again. The
cutting blade (4) moves back to its starting position.
4. Remove the can opener from the can. The lid is re-
moved directly when you do this by the magnet (3) on
the bottom of the can opener.

Cleaning and Storage

CAUTION!
■ Danger of injury! The cutting blade is sharp!
■ Remove the batteries from the product before clean-
ing the cutting blade.
■ Do not use any corrosive or abrasive cleaning agents
or cleaning pads to clean the product.
■ The product is not dishwasher-safe!
• Remove the protective cap (5) on the cutting blade (4)
prior to cleaning.
• Clean the cutting blade and the housing with a damp
cloth and mild washing-up liquid if necessary.
DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •
*) Calls to German landlines are subject to charges. The cost varies depending on the service provider.
•
•
Troubleshooting
If the product does not work properly, fi rst check whether
you are able to rectify the problem yourself.
1. Slide the battery
compartment cover
Problem
in the direction of the
arrow and remove it.
2. Insert two batteries
of the AA type, 1.5 V.
Pay attention to the The product
correct polarity (+ / –). only works
slowly or
not at all.

Technical Data

Product number: 01185
Model number:
Power supply:
Disposal
1. Place the can opener
onto the can from
above. The edge of
the can must be in
the gap between the
cutting blade (4) and
the guide wheel (2)
(see illustration).
Customer Service / Importer:
All rights reserved.
4
Then dry all components with a soft cloth and reattach
the protective cap (5). You should feel and hear it click
into place.
Store the product in a dry, clean place that is not ac-
cessible to children and animals.
Do not attempt to repair a defective electrical
product yourself!
Possible cause / solution
• Have the batteries been inserted?
Insert two 1.5 V batteries, AA type
into the product (see the "Insert-
ing / Changing Batteries" section).
• Are the batteries which are inserted
dead? Change the batteries (see the
"Inserting / Changing Batteries" sec-
tion).
• Is the cutting blade (4) seated cor-
rectly on the edge of the can? Adjust
the fi t (see the "Use" section).
KC86
3 V DC (2 x 1.5 V battery, AA type)
The packaging material is recyclable. Dispose of
the packaging in an environmentally friendly man-
ner and take it to a recycling centre.
Dispose of the product in an environmentally
friendly manner. It should not be disposed of in the
normal domestic waste. Dispose of the product at
a recycling centre for used electrical and electron-
ic devices. More information is available from your
local authorities.
The batteries should be removed prior to disposal
of the product and disposed of separately from
the product. To protect the environment, non-re-
chargeable and rechargeable batteries must not
be disposed of with normal household waste, but
must be taken to suitable collection points. Also
note the relevant statutory regulations governing
the disposal of batteries.
✆
+49 38851 314650 *)
Instructions
Z 01185 M DS V1.1 0217