Cleaning And Storage; Troubleshooting - DS Produkte SLG5003-18 Mode D'emploi

8. Keep the device closed for a few minutes. Remove your food when it is as cooked
and brown as you want it to be.
Use only a wooden or plastic utensil to remove your food.
9. Disconnect the device from the mains power after use and allow it to cool down
before you clean it.

Cleaning and Storage

CAUTION!
■ Remove the plug from the mains socket before doing any cleaning.
■ Do not immerse the device in water or other liquids to clean it.
■ Do not put the device in the dishwasher to clean it.
■ Always allow the device and the contents of the fat collecting tray to cool down com-
pletely before you clean the parts and dispose of the contents.
■ Do not use any corrosive or abrasive cleaning agents to clean the device. These can
damage the surface.
• Make sure the device is switched off!
• Clean the device and grill plates with a soft kitchen towel and a little mild detergent.
Then dry the device well.
• Clean the fat collecting tray using hot water and mild detergent. Then thoroughly dry
the tray.
• Store the device and the fat collecting tray in a dry, protected place.

Troubleshooting

If the device is not working properly, please check fi rst of all whether you are able to
rectify a problem yourself.
Do not attempt to repair a defective device yourself!
Problem
The device does not work
/ the operating lamp does
not light up.
The heating control lamp
goes out and lights up
again at regular intervals.
TGK_DE-EN-FR-NL_A5_V2.indb 17 TGK_DE-EN-FR-NL_A5_V2.indb 17
17
Possible cause / solution
• Is the mains plug correctly inserted in the plug socket?
• Is the plug socket defective? Try another plug socket.
• Check the fuse of your mains connection.
• During the grilling process, the control lamp may light
up and then go out again. When the control lamp lights
up, this means that the device is heating again in or-
der to maintain a constant temperature. This is not a
malfunction!
EN
19.04.2016 16:21:12 19.04.2016 16:21:12