Measuring Mode - geo-FENNEL FCT1 Data Mode D'emploi

EN
>Delete
>>Current data
>>All data
>>Groupdata
>Measurement view
>Calibration
>>Enable
>>Disable
>>Delete Zero N
>>Delete Zero F
BASIC SETTINGS
Switch instrument on and enter into menu by pressing red button. Select program requested with but-
tons UP/DOWN and confirm with SELECT (quit with ESC). In the sub-menu select function requested
with red button and confirm with SELECT (quit with BACK). When setting is finished quit with BACK
(see MENU).

MEASURING MODE

Continuous measurement mode: It can sometimes be of advantage if the probe does not need to be
raised between each measurement so that there is a running display of readings. In continuous mode,
readings are not accompanied by a beep. All readings taken in this mode will auto matically be stored in
the statistics program as long as sufficient memory is available.
Single mode: In single mode readings are accompanied by a beep. Besides, others are same as conti-
nuous measurement mode.
PROBE
In AUTO mode the probe automatically recognizes the metal to be measured (magnetic or non-
magnetic) and automatically selects the measuring principle:
- magnetic induction principle for ferrous metals (Fe) or
- eddy current principle for non-ferrous metals(No-Fe).
Alternatively the mode can be selected manually.
UNITS
You can switch between metric units (μm, mm) and imperials (mils).
TOTAL RESET
A total reset erases data from all memories. This includes all sets of readings of all work modes and
their associated statistics, calibration values and tolerance limits.
21