Battery; Keypad/ Display Indication; Display Symbols - geo-FENNEL FCT1 Data Mode D'emploi

BATTERY

If instrument cannot be switched on battery power is too week or there is no battery inside -> insert a
new battery.
If display shows
Unscrew the screws from the battery cover and remove the battery cover. Replace battery by a new
one and take care to correct polarity.
Close battery cover and screw in the screws again.
Note
Low battery power may lead to wrong measuring results.

KEYPAD/ DISPLAY INDICATION

1. Probe
2. USB port
3. Display
4. Menu: ESC/NO/BACK Working mode: ON/OFF
backlight illumination
5. Menu: OK/YES/MENU/SELECT
6. Button: DOWN/RIGHT
7 . Button: UP/LEFT
8. Button: ZERO CALIBRATION
9. Button: OF/OFF

DISPLAY SYMBOLS

NFe Non-magnetic metal (automatic recognition)
Fe Magnetic metal (automatic recognition)
AUTO Automatic recognition of metal
F/N Calibration symbol (see menu page 20)
DIR Direct measuring mode
GRO1..4 Group measuring mode
μm Unit mikrometer
mils Engl. unit
AVG Average value
MIN Minimum value
MAX Maximum value
Sdev. Standard deviation
NO Number of measurements
and the instrument switches off immediately after power on - > replace battery.
2
5
9
1
EN
G
H
3
6
8
19