Horizontal Angle Clockwise/Anti-Clockwise; Hal; Horizontal Angle Hold; Measuring A Percent Of Grade (%) - geo-FENNEL ELT 220 Mode D'emploi

HORIZONTAL ANGLE CLOCKWISE/ANTI-CLOCKWISE (HA
Aim at target "A" using the crosshair of the telescope.
Press "R/L " key, to change transform horizontal angle mode HA
Measuring by mode HA
Press "R/L " key once again to change mode HA
HORIZONTAL ANGLE "HOLD"
Turn the tangent screw until you have the required horizontal angle.
Press "HOLD" key once, and the value of the horizontal angle "blinks" .
Press "HOLD" key once again to hold the horizontal angle.
Aim at the target.
Press "HOLD" key, once again to release at the required horizontal angle.
The "HOLD" key has no effect on the vertical angle.
MEASURING A PERCENT OF GRADE (SLOPE MEASUREMENT %)
Press "V%" the display of vertical angle switches to percent of grade. Press "V%" again.
The display reverts back to normal angle measurement mode.
ANGULAR REPEATED MEASUREMENT
1 Press "SFT" key
2 Press "REP" key
3 Aim at a target "A" and press "0SET" key
4 Aim the target "B"
5 Press "HOLD" key
6 Aim the target "A" once again and press "0SET" key
7 Aim the target "B" once again
8 Press "HOLD" key
9 Repeat 2-8 to measure the desired number of repetitions
10 Press "SFT" to exit from this mode
. "R/L " key has no effect on the vertical angle.
L
into the mode HA
R
into mode HA
L
R
ECOLINE
EN
/HA )
L
R
.
L
23