Change The Batteries; Vertical Angle 0 Error Correction - geo-FENNEL ELT 220 Mode D'emploi

EN

CHANGE THE BATTERIES

Removing the alkaline / rechargeable battery
When using alkaline batteries:
Push down the press button and remove the battery compartment.
Battery replacement:
Push down the catch to remove the battery compartment cover.
Replace the alkaline batteries / charge rechargeable battery. Ensure correct polarity when replacing the
batteries.
Snap the battery compartment cover back into place.
Replacing the alkaline / rechargeable battery:
Slip the projection on the bottom of the battery compartment into the slot. Push the press button on
top of the battery compartment until it clicks into place.
HORIZONTAL ANGLE OSET (0SET)
∙ Aim at target "A" using the crosshair of the telescope.
∙ Press "0SET" key twice to set reading of horizontal
angle reading to 0°00' 00" .
∙ "0SET" key is only effective on to the horizontal
angle.
∙ Horizontal angle can be set to "0" at any time except
when using the hold function (HOLD key).

VERTICAL ANGLE 0 ERROR CORRECTION

∙ Power on while pressing "R/L " , "SETUP" is displayed.
∙ "SET F1" will display on the first line and "blink"
∙ Level the instrument and align to the reference target in normal telescope position (Face
1), press "0SET" the first line will blink and display "SET F2" .
∙ Transit and traverse the telescope (Face 2) align to the same target, press "0SET" the
first line will blink and display "SET" .
∙ Press "0SET" to confirm correction and enter the angle measuring mode.
∙ If you want to exit at any time, you can press "SFT" .
22